Stainless steel is a long history of wear resistant material, under the bad working condition, it is not easy to produce the plastic instability, which has fairly good abrasion resistance.
Stainless steel is a kind of filtering net blades used in sieving filter metal mesh structure components.
Stainless steel has high strength, stiffness and bearing capacity, can make all kinds of the shape of the rigid screening filter.
Stainless steel filter is a kind of using manganese steel mesh wire diameter is 1.
6mm-
12 mm silk thread woven mesh products, it USES embedded weaving, warp/weft overlapping point is not outstanding, with smooth surface, and uniform stress.
Stainless steel filter is square of all kinds of metal wire woven mesh with a variety of utility products, is to use special high manganese steel, compiled and become, have anticorrosive, wear-resisting, high points sieve rate, etc.
Stainless steel filter due to work hardening phenomenon, should avoid to casting process.
Holes in the casting, cast out as much as possible.
But for the stainless steel filter processing is not impossible.
Tool finishing a feed processing can be finished, the inevitable processing to be amplified with casting process design processing capacity, in order to make the amount of feed processing to avoid work hardening layer.
Stainless steel welding performance of filtering net blades: high manganese steel reheating, in 250 ~ 800.
The brittle temperature range of the carbide precipitation, between C and as-cast high manganese steel and carbide network existing and casting stress, therefore, the welding performance is poor.
High manganese steel castings, should be cut after water toughening treatment riser or weld defects, should be rapid cooling after welding.
As much as possible to eliminate or reduce the heat affected zone, the application of small current, discontinuous welding, welding or side water cooling.
Use high manganese steel welding electrode electrode or austenitic stainless steel electrode.
If there is work hardening layer, should be removed prior to welding.
Above is the related contents of stainless steel pieces, the hope can help you.