Stainless steel mesh belt will use heat bilges cold shrink;
Transport stainless steel mesh belt and general metals have heat bilges cold shrink phenomenon.
Transport because of the working environment, stainless steel mesh belt will heat due to the conflict in the job, when conflict in secure beyond 400 ℃ swell the condition of the formation of intermittent decrease between the whole machine, stainless steel mesh belt will also present the corresponding change.
Stainless steel mesh belt use the cause of non-uniform stress;
1, perhaps is the mesh belt tensioning equipment mistake, lead to delivery on both sides of the mesh belt tension is inconsistent;
2 joint part of the transport, stainless steel mesh belt conveyer is not smooth, the transport stainless steel mesh belt mesh belt slack will also lead to wandering;
3, transport in the stainless steel mesh belt conveyer in the delivery of material spread unevenly, roller and chain plate on both sides of the conflict, and even in the drum material viscosity and forms an uneven phenomenon;
(4), net belt conveyer roller can also lead to net belt conveyer running deviation, lead to uneven.
Stainless steel mesh belt factory use device tight;
Stainless steel mesh belt device is required.
About stainless steel wire mesh has said, we want to more permanent applied to it, we don't put the device when the device too close, because it would drop its using life.
1, stainless steel mesh belt device too close, is not conducive to the future maintenance of protection operation, also be a hazard to equipment, and then fell from the quality of the product.
2, when the stainless steel mesh belt device too close, will add a mesh belt between the device and pressure, and after the equipment run, and will increase conflict between the mesh belt and mechanical force.
If you want to know the big conflict will not only form a mesh belt wear, also can form mechanical equipment wear and tear, eventually will directly affect the equipment and the use of the stainless steel mesh belt life.
Using stainless steel mesh belt factory used in corrosive environment?
Stainless steel mesh belt parts.
Accelerated wear and tear, rust on the parts affect roller chain hinge and sensitive reversed;
Also a stress corrosion and grain corrosion is present.
Selection of chain is used in corrosive environment, it is necessary to pay attention to the chain parts material selection.
Whether made parts of martensitic stainless steel series chain rust only depends on operation conditions.
Grasp the corrosion resistant ability to correctly use chain in corrosive environment.